master power 3+

The Master Power 3+ brings the acclaimed sound of Dan D'Agostino Master Audio Systems amplifiers to home theaters and advanced 2.1-channel stereo systems. Borrowing heavily from the amplification circuits D'Agostino developed for the Momentum amplifiers, the three-channel Master Power 3+ adds flexible crossover, bussing and bridging capabilities that optimize it for any system, from traditional two-channel to the immersive sound of Dolby Atmos and DTS X.

The switchable crossover filters the bass out of any channel to drive satellite speakers—or the mids and treble out of any channel to drive a subwoofer. Of course, any or every channel can run full-range, too. A single audio signal can be routed to one, two or all three channels. Channels 2 and 3 can be bridged to deliver 1,000 watts into 8 ohms. Power can be controlled through a 12-volt trigger input or through RS-232, and the Master Power 3+ is rack-mountable.

Like the Momentum amplifiers, the Master Power 3+ is built by hand in D'Agostino's Arizona factory, using expensive through-hole construction for the best possible sound quality and reliability.

  • Power


  • Bridged Power

  • Frequency Response

  • Crossover Filters
  • Distortion

  • Signal-to-Noise Ratio
  • Inputs

  • Input Impedance
  • Output Impedance
  • Dimensions

  • Drawings
  • RS232
  • Owner's Manual
  • Additional Photographs
  • 300 watts @ 8Ω
    600 watts @ 4Ω
    1200 watts @ 2Ω
  • 1,000 watts @ 8Ω
    (Channels 2 + 3)
  • 1 Hz to 200 kHz, -1 dB
    20Hz to 20 kHz, ±0 dB
  • 80 Hz, -18 dB/octave
  • < 0.1% at 1 kHz
    300 watts/8 ohms
  • 100 dB, unweighted
  • 3 balanced XLR
    (XLR to RCA adapters supplied)
  • 100KΩ
  • 0.12Ω
  • 11.5 x 19 x 20 inches
    128 lbs.
  • View/Download
  • Download
  • Download
  • View