master power 3+

The Master Power 3+ brings the acclaimed sound of Dan D'Agostino Master Audio Systems amplifiers to home theaters and advanced 2.1-channel stereo systems. Borrowing heavily from the amplification circuits D'Agostino developed for the Momentum amplifiers, the three-channel Master Power 3+ adds flexible crossover, bussing and bridging capabilities that optimize it for any system, from traditional two-channel to the immersive sound of Dolby Atmos and DTS X.

The switchable crossover filters the bass out of any channel to drive satellite speakers—or the mids and treble out of any channel to drive a subwoofer. Of course, any or every channel can run full-range, too. A single audio signal can be routed to one, two or all three channels. Channels 2 and 3 can be bridged to deliver 1,000 watts into 8 ohms. Power can be controlled through a 12-volt trigger input or through RS-232, and the Master Power 3+ is rack-mountable.

Like the Momentum amplifiers, the Master Power 3+ is built by hand in D'Agostino's Arizona factory, using expensive through-hole construction for the best possible sound quality and reliability.

Finish Silver
Black
Custom Finishes Available Upon Request
Power 300 watts @ 8Ω
600 watts @ 4Ω
1200 watts @ 2Ω
Bridged Power 1,000 watts @ 8Ω
(Channels 2 + 3)
Frequency Response 1 Hz to 200 kHz, -1 dB
20Hz to 20 kHz, ±0 dB
Crossover Filters 80 Hz, -18 dB/octave
Distortion < 0.1% at 1 kHz
300 watts/8 ohms
Signal-to-Noise Ratio 100 dB, unweighted
Inputs 3 balanced XLR
(XLR to RCA adapters supplied)
Input Impedance 100KΩ
Output Impedance 0.12Ω
Dimensions 11.5 x 19 x 20 inches
Weight 128 lbs.
Drawings View/Download
RS232 Download
Owner's Manual Download
Additional Photographs View